Jap model 0 - how to split the crankcase
Page 1 of 1 • Share •
Jap model 0 - how to split the crankcase
I have a Jap model 0 and I am trying to split the crankcase so I can get to the big end bearing. I have tried all ways to get the flywheel off without success so I am attacking the problem from the shaft side. There is what appears to be a plastic bearing cover which I assume needs to be removed but how can I do this without damaging it? Is it even possible to split the crankcase from this side or am I heading the wrong way completely. Any help would be welcome as this is a nice little engine and will make a great showpiece when finished but is being very stubborn.
Rooneysowner- Born to be wild
- Posts : 13
Join date : 2013-09-08

» Die cast crankcase vs. extruded...
» 3-D TARDIS Model Kit book review wanted
» Bristol Model Engineering Show
» -Model engineers exhibition
» 1909 Stanley Model R - 20 HP - Coffin Nose
» 3-D TARDIS Model Kit book review wanted
» Bristol Model Engineering Show
» -Model engineers exhibition
» 1909 Stanley Model R - 20 HP - Coffin Nose
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum