Please log in , the forum is open to guests who are now able to view every section, feel free to become a member , you will then be able to post and reply to topics.

kelvin engin

Go down

kelvin engin

Post by spanneritse on Sun Aug 03 2014, 12:18

Hi all hoping that someone will know how to time the valves on a kelvin 3hp single poppet valve, was going fine until the mag sprocket fell off and stripped four of teeth on the fiber cam drive thats driven by a cog on the flywheel, i put another drive on but theirs no timing marks on it,got it running (trial and error, flywheel on and off at least a thousand times) but not right its blowing oil out, and fuel out the carb and just runs for a minuet or two ,,,,I have a vague memory about something to do with degrees and valve timing,,,but hoping that someone will know how it's done,,,,,kenny

Born to be wild
Born to be wild

Posts : 13
Join date : 2014-01-16

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum