Autogil Guillotine Infomation
3 posters
Page 1 of 1
Autogil Guillotine Infomation
Is anyone familiar on Augil guillotines, what the correct/advised operating speeds?
Regards
George
Regards
George
george123- Posts : 4
Join date : 2009-10-11
autogil
hi george the max is 500 rpm you will need speed reduction for differant grades of steel you are cutting regards graham , will need your help soon to lift lister .
listerman36- Expert
- Posts : 53
Join date : 2009-09-19
Age : 65
Location : yalding
Re: Autogil Guillotine Infomation
What are we planning on making with the sheet metal your cutting up
Chris
Chris
JONESEY- Admin
- Posts : 2848
Join date : 2009-07-21
Age : 61
Location : Verwood, Dorset
Re: Autogil Guillotine Infomation
thanks Graham, do you ahve anymore info on it like a book or something? yeah sure just give me a buzz or pm me the night before il come and give you a hand
well once i rig it up with an engine il have ago cutting some patches for my landrover, i only need two patches but it could be fun, its only small but should do the job ok hopefully lol, its all good fun, it would make an interesting rally exhibit, ive never seen one before, il post a picture either tomjorrow or monday
thanks
George
well once i rig it up with an engine il have ago cutting some patches for my landrover, i only need two patches but it could be fun, its only small but should do the job ok hopefully lol, its all good fun, it would make an interesting rally exhibit, ive never seen one before, il post a picture either tomjorrow or monday
thanks
George
george123- Posts : 4
Join date : 2009-10-11
Re: Autogil Guillotine Infomation
Sounds good fun watch you fingers
Chris
Chris
JONESEY- Admin
- Posts : 2848
Join date : 2009-07-21
Age : 61
Location : Verwood, Dorset
Similar topics
» Villiers poor spark (post moved to suitable section)
» my new project a twin cylinder jap model 55 petrol parrafin engine
» my new project a twin cylinder jap model 55 petrol parrafin engine
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|