Stuart R2 control box
2 posters
Page 1 of 1
Stuart R2 control box
Hi All,
I recently obtained another Stuart Turner R2 unit ( base plate,engine,dynamo and control box),apart from problems with the engine, the control box has some bits missing( I am not very electrically minded!) and I was wondering if anyone here could identify and let me know whats missing and hopefully where to obtain the missing bits? I would add that I have a circuit diagram for a 12 volt unit but it does not appear to bear any resemblance to this unit,eg there is a ceramic bit in the bottom right of this unit which is not shown in the 12v circuit diagram.
The details are :- engine 33124, watts 300,volts 22/38, amps 35/75, dynamo 63A235, switch board 5571
Any help or advice would be much appreciated.
All the best,
Kev.
I recently obtained another Stuart Turner R2 unit ( base plate,engine,dynamo and control box),apart from problems with the engine, the control box has some bits missing( I am not very electrically minded!) and I was wondering if anyone here could identify and let me know whats missing and hopefully where to obtain the missing bits? I would add that I have a circuit diagram for a 12 volt unit but it does not appear to bear any resemblance to this unit,eg there is a ceramic bit in the bottom right of this unit which is not shown in the 12v circuit diagram.
The details are :- engine 33124, watts 300,volts 22/38, amps 35/75, dynamo 63A235, switch board 5571
Any help or advice would be much appreciated.
All the best,
Kev.
Locknut- A credit to the forum
- Posts : 255
Join date : 2013-02-20
Location : South Devon
Re: Stuart R2 control box
Have you tried:
https://groups.yahoo.com/neo/groups/stinfoexchange/info
https://groups.yahoo.com/neo/groups/stinfoexchange/info
_________________
Regards Paul
Tha can alus tell a Yorkshireman - but tha can't tell him much.
Woodsman- Admin
- Posts : 2683
Join date : 2014-08-24
Age : 73
Location : God's own county
Re: Stuart R2 control box
Hi Paul,
Thanks for that - I am member of that site and have posted an information request.
All the best,
Kev.
Thanks for that - I am member of that site and have posted an information request.
All the best,
Kev.
Locknut- A credit to the forum
- Posts : 255
Join date : 2013-02-20
Location : South Devon
Similar topics
» the stuart issue
» Amanco Hired Man Governor Latch speed control spring diameter?
» Stuart Turner A4
» STUART MAG
» stuart turner p5 x
» Amanco Hired Man Governor Latch speed control spring diameter?
» Stuart Turner A4
» STUART MAG
» stuart turner p5 x
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|